Socket-mobile Bluetooth iPAQ Manual do Utilizador descarregar pdf (Página 16)

STEP 3: TURN ON THE BLUETOOTH CHS

Press and hold the small power button for 3 seconds, until the LED turns

blue and the scanner beeps twice (low-high). The LED should blink blue once

per second to show that the Bluetooth radio is on but not connected.

After the scanner is turned on, its Bluetooth mode will change over time if no

connection is made.

Note: This Bluetooth mode sequence is for the Bluetooth CHS v2.

Time after turning on scanner Bluetooth mode

0-5 minutes Discoverable and connectable

5-20 minutes Connectable

20 minutes Scanner automatically powers off

STEP 4: START BLUETOOTH ON YOUR COMPUTER

Note: Refer to your Bluetooth hardware/software documentation for full

instructions.

1. If using an add-on Bluetooth card or adapter, such as the Socket Scanning

Companion USB adapter, plug it into your computer.

2. Start your computer’s Bluetooth software. For some computers, the Bluetooth

software will automatically launch after you turn on the Bluetooth radio.

3. Turn on the Bluetooth radio. For some computers, the Bluetooth radio must be

enabled through the software. Other computers have a hardware switch.

Note: Your Bluetooth software may vary from the screen shown.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 113 114

Sem comentários

Socket-mobile Bluetooth iPAQ Manual do Utilizador Página 16